MATERIAL SAFETY DATA SHEET
Discontinued:
Date of Preparation: 10/19/2007
Page 1of 7
SECTION I - Product and Company Description

Product Name: Adhesive 5 Minute Epoxy (Part B)
Product Use: Epoxy Curing Agent
Product Number: 11-676148-000B

Company: Brunswick
525 W. Laketon
Muskegon, MI 49443

Telephone #: 1/231/725-4972
Emergency #: 1/800/255-3924
CHEMTEL #: 1/800/255-3924
International CHEMTEL #: 1/813/248-0585

SECTION II - Composition/Information on Ingredients
HAZARDOUS
INGREDIENT
MATERIAL DESCRIPTION
REF#		CAS#ECN#SARA
313
Y/N
% Wt.
Triethylene Tetramine
Propoxylated Triethylene Tetramine
Diethylenetriamine
Triethanolamine
Piperazine
N-Aminoethylpiperazine		26950-63-0
00112-24-3
00111-40-0
102-71-6
110-85-0
140-31-8		Y 25.0
Y 25.0
Y 5.0
Y 5.0
Y 5.0
Y 5.0
NONHAZARDOUS
INGREDIENT
MATERIAL DESCRIPTION
REF#		CAS#ECN#SARA
313
Y/N
% Wt.

This product contains a chemical reported to be a carcinogen or suspected carcinogen.
SECTION III - Hazards Identification

General Hazard - Primary - CORROSIVE LIQUID, N.O.S. Secondary - COMBUSTIBLE Health studies have shown that many epoxy resin and catalyst systems may pose human health risks which may vary from person to person. As a precaution, exposure to liquids, vapors, mists or fumes should be minimized. Overexposure: Skin Contact - Irritaion or burns may be caused by skin contact especially with prolonged contact. Eye Contact - May cause moderate to severe irritation or burns. Inhalation - May be irritating to mucous membranes and may produce an allergic reaction. Ingestion - May cause irritation of gastrointestinalPre-existing medical conditions of dermatitus may be aggravated by this product.
11-676148-000B
Adhesive 5 Minute Epoxy (Part B)
MATERIAL SAFETY DATA SHEET
Page 2 of 7
SECTION IV - First Aid Measures

EYE CONTACT: Flush with lukewarm water for 15 minutes. Contact physician.
SKIN CONTACT: Do not remove with solvent. Use waterless hand cleaner followed by soap and water. Remove and clean contaminated clothing.
INHALATION: Remove exposed individual to fresh air. Restore breathing, if necessary. Get medical attention.
INGESTION: Rinse mouth. Call a physician or Poison Control Center immediately. DO NOT induce vomiting unless advised by a physician.
SECTION V - Fire-Fighting Measures

EXTINGUISHING MEDIA: Use CO2, Dry Chemical or Foam
SPECIAL RISKS: Vapors heavier than air. Development of hazardous combustion gases or vapors possible in the event of fire.
SPECIAL PROTECTIVE EQUIPMENT FOR FIRE FIGHTING: Fire Fighters should use self-contained breathing apparatus with face piece.
OTHER INFORMATION: Keep away from sources of ignition. Prevent fire-fighting water from entering surface water or groundwater. Cool Container with spray water from a safe distance. Never use welding or cutting torch on or near container (even empty) because product may ignite explosively.
SECTION VI - Accidental Release Measures

PERSON RELATED PRECAUTIONARY MEASURES: Avoid substance contact. Do not inhale vapors. Ensure fresh air supply in enclosed areas.
ENVIRONMENTAL PROTECTION MEASSURES: Do not allow to enter sewage system, surface or groundwater.
PROCEDURES FOR CLEANING/ABSOPRTION: Use inert absorbent material to take up spilled material. Place in appropriate container until proper disposal method is determined.
SECTION VII - Handling And Storage

NOTES FOR PREVENTION OF FIRE AND EXPLOSION: Keep away from sources of ignition. Use and store this product with adequate ventilation.
NOTES FOR SAFE HANDLING: Avoid generation of vapors. Do not inhale vapors.
STORAGE: Store in well-ventilated area between 40 F (4C) and 100 F (38C). Store away from heat and sources of ignition.
Brunswick takes no responsibility for determining what measures are required for personal protection in any specific application. The general information given should be used with discretion.


11-676148-000B
Adhesive 5 Minute Epoxy (Part B)
MATERIAL SAFETY DATA SHEET
Page 3 of 7
SECTION VIII - Exposure Controls/Personal Protection

Hazardous
Component		ACGIH
TLV(TWA)
PPM		OSHA
PEL
PPM
Triethylene Tetramine
Propoxylated Triethylene Tetramine
Diethylenetriamine
Triethanolamine
Piperazine
N-Aminoethylpiperazine		Not established
Not established
Not established
N/I
N/I
N/I		Not established
Not established
Not established
N/I
N/I
N/I
NonHazardous
Component		ACGIH
TLV(TWA)
PPM		OSHA
PEL
PPM

PERSONAL PROTECTIVE EQUIPMENT: Protective clothing should be selected specifically for the working place, depending on concentration and quantity of the substances being handled. The resistance of the protective clothing should be ascertained from the respective supplier.

RESPIRATORY PROTECTION: Required when vapors are generated.

EYE PROTECTION: Splash goggles.

HAND PROTECTION: Chemical resistant gloves and skin cream.

INDUSTRIAL HYGIENE: Immediately change any contaminated clothing. Apply skin protective barrier cream. Wash hands and face after handling product. Do not inhale vapors.
SECTION IX - Physical and Chemical Properties

Physical State: Thick liquid
Odor: Slight amoniacal odor
pH: slightly basic
Viscosity:
Lowest Flashpoint: >150 ° F. (65.6 C)
Explosion Level: Lower - No data Upper - No data
Vapor Pressure: <15 mm Hg
Vapor Density: (Air = 1) >1
Weight Per Gallon: 9.1 lbs./gal.
Solubility: < 5% in water


11-676148-000B
Adhesive 5 Minute Epoxy (Part B)
MATERIAL SAFETY DATA SHEET
Page 4 of 7
SECTION X - Stability and Reactivity

Conditions to be avoided: CAUTION - COMBUSTIBLE ****Large Spills**** Eliminate potential sources of ignition. Wear appropriate respirator and other protective clothing. Shut off source of leak only if safe to do so. Dike and contain. Remove with vacuum trucks or pump to storage/salvage vessels. Soak up residue with an absorbent material such as clay, sand or other suitable material, place in non-leaking containers and seal and seal tightly for proper disposal. **** Small Spills**** Take up with absorbent material such as clay, sand or other suitable material, place in non-leaking containers and seal and seal tightly for proper disposal.
Substances to be avoided:
Hazardous decomposition products:
Further information:
SECTION XI - Toxicological Information

Acute Toxicity:
None available

Specific symptoms in animal studies:
Subacute to chronic toxicity:
Bacterial mutagenicity:
Further toxicological information:

Further Data:



11-676148-000B
Adhesive 5 Minute Epoxy (Part B)
MATERIAL SAFETY DATA SHEET
Page 5 of 7
SECTION XII - Ecological Information

Biologic degradation:

Ecotoxic effects:
Biological effects:
Fish toxicity:
Daphnia toxicity:
Maximum permissible toxic concentration:
Algeal toxicity:
Bacterial toxicity:
Protozoa:
Further ecological data:
SECTION XIII - Disposal Considerations

Product: Chemicals must be disposed of in accordance with national and local regulations.

Packaging: Packaging must be disposed of in compliance with national and local regulations.


11-676148-000B
Adhesive 5 Minute Epoxy (Part B)
MATERIAL SAFETY DATA SHEET
Page 6 of 7
SECTION XIV - Transportation Information

Package Desc: 1 Fiberboard box containing 2 X 1oz plastic bottles
Weight: 1 #
Dimensions:
Freeze/Thaw stable: NA
Flashpoint: >150 ° F. (65.6 C)

Land transport:
Classification: ORM-D Consumer Commodity
Name:

Transport by sea:
Classification: UN1760, Corrosive Liquid, N.O.S. (Contains Triethylenetetramine), 8, II, LTD QTY
EMS F-A, S-B
MFAG
Name

Transport by air: DO NOT SHIP AIR
Classification:
Name:
Packaging Instructions:

The transport regulations are cited according to international regulations and in the form applicable in the United States. Possible deviations in other counties are not considered.
THIS TRANSPORT DATA APPLIES TO THE ENTIRE PACKAGE.
SECTION XV - Regulatory Information

Labeling according to Land Transport:
Hazard:
Package: ORM-D - Consumer Commodity
Other: Orientation Arrows

Labeling according to Sea Transport:
Hazard: none
Package: Corrosive Liquid, N.O.S. (Contains Triethylenetetramine), UN1760. LTD QTY
Other: Orientation Arrows

Labeling according to Air Transport
Hazard: DO NOT SHIP AIR
Package:
Other: Orientation Arrows


11-676148-000B
Adhesive 5 Minute Epoxy (Part B)
MATERIAL SAFETY DATA SHEET
Page 7 of 7
SECTION XVI - Other Information



The information contained herein is information received from our raw material suppliers and other sources and is believed to be reliable. This data is not to be taken as warranty or representation for which Brunswick assumes legal responsibility.

This Safety Data Sheet complies with EC Commission Directive 2001/58/EC of July 2001